3d-MagSSPEI310S - Magnetic PEI Coated Spring Steel Sheet 310 x 310 For CR10/CR10S etc.
1.Black PEI powder
2.PEI sheet :Ultem PEI sheet ,thickness 0.15mm ,temperature resistance: more than 200degree.
3.Spring steel sheet: thickness 0.4mm,0.5mm are available ,very flat and the temperature transfer ,flexibility very good.
4.working temperature up to 130 degree
Good flatness, magnetism and flexibility spring steel sheet
Thickness 0.4mm ,0.5mm are available
Amber PEI power coated type
Magnetic PEI coated spring steel sheet including :
1. Smooth PEI or PEI power layer
2. Spring steel sheet
3. Magnetic base
- PLA – 60C
HTPLA – 60C
PETG – 70-80C
PCTG – 70-80C
ABS – 100C
2.Product Usage Guidelines
Part Removal– Make sure your plate is at close to room temp (under 30C) before removing parts. If you remove when hot it is more likely to damage the surface
After apply the PEI sheet on our special spring stainless steel sheet, You can simply use 4 clips or magnets to hold it on the heatbed, then enjoy the printing.
Easily remove 3D prints on printer by removing the spring steel plate, flexing it, and popping the print off. It's simple and makes the print removal process much easier.
For details, Check the guide video on Youtube
Available size :
|Customize any size according to your drawing|
Please contact Printsource3d if a different size is required as we only stock the 235 x 235 mm and the 310 x 310mm
Doubled-sided PEI Powder-coated spring steel sheet with magnet 3M base makes for the best all around build surface. Textured or smooth finish depending on the side you use. Easy to remove plate from printer then simply bend a little to pop prints off.
Powder coating directly on metal makes it very hard to damage this build plate. If a heated nozzle crashed into it, the metal can dissipate the heat. Powder coating also gives the surface a distinct textured look that will be visible on your prints. The textured surface hides most of the mechanical damage caused by tools.
PLA ABS PETG TPU PVA etc.
310 x 310mm
Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface. If printing PETG, TPU, TPE, and RYNO, make sure the bed is heated BEFORE attempting to remove the print from the bed.
1* Steel sheet
1* Magnet base